JAI TMC-4200GE User Manual download pdf (Page 29)

Page 17

TM-4200GE Software

Configuring the TM-4200GE Camera

FIGURE 19. Offset Level.

3.4.8 Look-Up Table

The look-up table (LUT) control, shown in Figure 20, allows you to change two knee point values.

FIGURE 20. Look-Up Table

Enter X

, Y

, X

, Y

values directly to adjust the knee curve. In the integrated camera software, the

look-up table can also be controlled interactively. The Table Selection pull-down menu allows you to

select the Linear or Gamma 45 option. This control also allows you to check the positive or negative

box to choose an image option. There is no LUT for 12-bit output.

3.4.9 Memory Pages

All the camera parameters such as shutter mode, shutter speed, gain, offset level, scan mode, and LUT

can be saved into seven available memory pages on the EEPROM in the camera. The pages are

numbered 0-6. The Load Page button loads the corresponding camera settings from the EEPROM while

the write page button writes the current camera settings to the corresponding memory page in the

EEPROM.

Page 1, shown in Figure 21, is the power-up default page. Page 0 is the factory default. To save your

current camera settings for power up default, write the settings to memory page 1.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 91 92

No comments

JAI TMC-4200GE User Manual Page 29