JAI TM-2016-8/8CL User Manual download pdf (Page 22)

Page 12

TM-2016-8 and TM-2016-8CL Progressive Scan Shutter Camera

Installation

2.2.6 Camera Link Cable (TM-2016-8CL only)

The Camera Link cable assembly (26CL-02-26) has a 26-pin MDR26 connector on both ends. This is a

straight-through cable. The pin-out configuration is shown in Table 4 on page 9.

Note: For the TM-2016-8CL model, serial communication for camera control is done via the

Camera Link connector on the rear panel of the camera.

2.2.7 Power Supplies and Power Cable Setup

2.2.7 (a) Power Supplies

The TM-1402 requires 12V DC power that is obtained through the 12-pin connector located on the rear

panel of the camera. JAI, Inc. recommends the following power supplies:

PD-12UU 100-240V AC/12V DC 1.2A universal voltage power supply with

(No 12-pin connector) US plug

PD-12UUP 100-240V AC 1.2A universal voltage power supply with US plug

and 12-pin connector

PD-12UE 100-240V AC/12V DC 1.2A universal power supply with European plug

(No 12-pin connector)

PD-12UEP 100-240V AC/12V DC 1.2A universal power supply with European plug and

12-pin connector

If you are providing power through the 12-pin connector, the PD-12UUP and PD-12UEP power

supplies are available with the 12-pin mating connector already attached to the leads from the power

supply. The PD-12UU or PD-12UE power supply can be connected to the JAI, Inc. power cable either

directly or via a terminal strip.

When wiring the PD-12UU power supply directly, please note the following:

• The lead ends must be twisted together and tin-soldered for strength and electrical continuity.

• Shrink tubing or a similar insulator should be used to prevent exposed leads from touching and

shorting.

• The +12V lead is marked with a red stripe or white lettering; be sure not to reverse the leads.

• All connections must be properly insulated to prevent shorting.

Thumbscrews

Cable

26 Position

High Density

Mini D Ribbon

(MDR) Male Plug

26 Position

High Density

Mini D Ribbon

(MDR) Male Plug

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 43 44

No comments

JAI TM-2016-8/8CL User Manual Page 22